By default these programs are located under C:\Program Files (x86)\SolidWorks SolidNetWork License Manager. Though not typically required with the default Windows Firewall, you may need to apply a rule to allow connection for programs lmgrd.exe and sw_d.exe. Follow the same steps 4-7 to allow outbound connection for ports 2575.Select Outbound Rules in the left pane and choose New Rule.Give a descriptive name for the rule such as “SolidNetWork License Manager Ports” and Finish.Opening a port within the Public profile is at your own risk and should be reviewed and approved by your IT. Verify your network settings to determine required access. NOTE: Allowing access through the Public profile is not recommended.
Choose the appropriate profiles from Domain, Private, Public.This needs to be set to Allow the connection.Select Inbound Rules in the left pane and choose New Rule.Select Advanced settings in the left panel.Go to Windows Control Panel > Windows Firewall.For the default Windows firewall, the follow process can be taken. The performance of the assemblies and drawings I made so far is not perfect but fair enough considering that it's under and VM and a 圆4 to ARM emulation.SOLIDWORKS SolidNetWork License Manager PortsĬommunication on ports 2575 must be allowable through the firewall for Inbound and Outbound communication. And then, create a DWORD_32 with the name ' Workarounds' and value in 0x4000480 (in hex).Īlso, in Key Gl2Shaders -> Other create a key with the name of your renderer `` ``` Parallels using Apple M1 Max (Compat) and Create a DWORD_32 with the name Workarounds and value in 0x4000480 (in hex). Then, I created a Key at the base key (Hardware) with the value of your vendor. Vendor (in my case it's Parallels and Apple) Renderer (in my case it's ' Parallels using Apple M1 Max (Compat)') This is the base key and from where all changes will be done.įirst go to Current and write down the values of the following keys that will be needed later: Open REGEDIT -> Go to HKCU -> Software -> Solidworks -> Solidworks 2021 -> Performance -> Graphics -> Hardware. To do it, I found many tutorials but none explaining how to do it with this version, so here goes the trick: Also, make sure that for the install at least the VM is isolated and doesn's sync the directories with your Mac, ten you can enable it back.īy some strange reason, the MSSQL DB that needs SW Electrical and Toolbox fails to install no matter what I try, so in the end I just skipped that part and install run smooth until the end.Īfter installing the license and activating the copy, everything was fine except that the graphics look quite bad as RealView is not enabled because the graphics card is not supported. Got a crash and failed install the first time I tried.
I created a Win11 Pro parallels VM with 32GB RAM to get started.
Just wanted to share my experience running SW on my M1 Max 64GB.
0 kommentar(er)
